Start Automatic Procedure - Mopar ECO NEXT ONE Manuel D'instruction

Select the model of vehicle you are servicing. (If you wish to install DATABASE contact the
machine dealer.), all the information about this model is displayed:
Press ENTER to confirm, and insert the value into the GAS FILLING field.
NOTE: if gas filling is lower than 100 grams the following popup warning will be displayed:
Gas filling lower than 100 grams is not allowed, press ENTER then digit an higher amount of gas
filling.

START AUTOMATIC PROCEDURE:

After selected all the procedure data, press ENTER to continue.
NOTE: if ECO NEXT ONE HFO or with analyzer enabled, the gas analysis will be performed
before recovery
NOTE: the STOP button
to exit to the main menu from all the procedure except the recovery and the charge ones. This
because by not completing a recovery procedure it is possible that some refrigerant remain in
the internal circuit and it may compromise the next procedure. In the final phase of the charge
the procedure hasn't to be paused or stopped to avoid to compromise the precision of the
procedure.
AUTOMATIC PROCEDURE will start, and the following screen will be displayed:
INSTRUCTIONS MANUAL
DATABASE
128i
135i
135is
1M
228i
DATABASE
BMW
I3 (I01)
ALL;3447
2013-
R134A: 750 g
Press ENTER to continue
Charge amount
Less than 100g/4oz
or unavailable quantity requested
Press ENTER to continue
(min 100g)
literally pause the running procedure. From the pause it is possible
STOP
-30-
DD/MM/YY XX:XX PM
ESC
DD/MM/YY XX:XX PM
ENTER
ESC
DD/MM/YY XX:XX PM
ENTER