Information About The Motor Features; Designated Use; Properties; Selve Commeo/Iveo Radio - Selve SE Plus-RC Mode D'emploi

GB

Information about the motor features

2. Information about the motor features

2.1. Designated use

The motor type SE Plus-RC must only be used for operating awnings or roller
shutters.

2.2. Properties

In order to protect the hangings, the drives have a self-programming overload detec-
tion in the upwards direction after the end limit setting has been completed.
Further notes:
The obstacle detection of the drives has been developed to protect the sun protection
installation, the insect protection or the obscuration system against damages.
Since, depending on the position of the hangings, when an obstacle is detected, the
entire hanging weight may have to be stopped before the object detection system trips,
do not use the motor's obstacle detection system for personal protection.
The airborne noise of the motor is significantly below 70 dB (A). Depending on the type
of the roller shutter/awning/screen a strengthening of the sound intensity of the motor
is possible. It can be reduced by use of appropriate measures (e.g. insula tion of the
box, using noise protection plugs, etc.).

2.3. SELVE commeo/iveo radio

All SELVE-RC motors receive radio signals on 868.1 MHz (commeo radio) and
868.3 MHz (iveo radio). The two radio systems can not be operated at the same time.
commeo is a bidirectional radio system that saves data in the receiver as well as the
transmitter. iveo is an unidirectional radio system which is compatible with the intronic
radio system.
The motor is compatible with both radio systems after it has been disconnected from
the mains supply as long as the teaching process for a commeo/iveo transmitter has
not already been completed. If you wish to change the radio system retrospectively,
the programming for all transmitters of the other radio system must be re-programed.
The motor must then be disconnected from the mains supply.
GB
All SELVE commeo/iveo transmitters can be programmed into these motors. Up to
16 transmitters can be programmed into one motor. Please adhere to the transmitter
operating instructions.
The commeo motors can be set for different applications in the CONFIGURATION
mode. The commeo motor SE Plus-RC is already set for 'awning'. During iveo operation
a change of the application is not possible.
Note:
Ensure that the controls are not installed and operated in the vicinity of metal surfaces
or magnetic fields. Metal surfaces or panes of glass with a metallisation within the
transmission path can reduce the range considerably.
Radio sets transmitting at the same frequency could interfere with reception.
It should be noted that the range of the radio signal is restricted by legislation and
constructional measures.
41