Information About The Motor Features; Designated Use; Properties - Selve SEE Notice

GB Information about the motor features

2. Information about the motor features

2.1. Designated use

The drive type SEE is ready for operation without setting the end limits and must only
be used for operating roller shutters.

2.2. Properties

The drive needs three complete moving up and moving down movements in order to
program its end limit positions and to set overload protection in upwards direction and
obstacle detection in downwards direction optimally.
The programming procedure will be executed automatically in the next days after
putting into operation and is completed when there is no longer a relief at the lower end
limit position.
To protect the hanging, the motors have an obstacle detection system after the limit
position setting in the downwards direction with a reversing function and a self-teach-
ing overload detection in the upwards direction.
The obstacle detection of the drives has been developed to protect the roller shutter
construction against damages.
Since, depending on the position of the hangings, when an obstacle is detected, the
entire hanging weight may have to be stopped before the object detection system trips,
do not use the motor's obstacle detection system for personal protection.
The airborne noise of the motor is significantly below 70 dB (A). Depending on the type
of the roller shutter/awning/screen a strengthening of the sound intensity of the motor
is possible. It can be reduced by use of appropriate measures (e.g. insulation of the
box, using noise protection plugs, etc.).
The stability of the roller shutter system has to be suitable for the permanent use of the
drive.
The drive is suitable for left and right installation controlled with conventional switches,
buttons and control systems that are suitable for roller shutter and sun control drives.
For the operation blocking springs/burglar proof fixations and fixed stoppers trailing
edges are mandatory.
There have to be at least two blocking springs/burglar proof fixations assembled and
have to be positioned and adjusted correctly to the roller shutter. The manufacturer
specifications for the blocking springs/burglar proof fixations have to be observed.
The drive torque has to be chosen correctly for the hanging weight.
Parallel connection of several drives is possible (please observe the capacity of the
switching elements!).
20