Selve SE Plus-RC Mode D'emploi page 51

commeo initial operation/Setting by radio
If multiple receivers have been found, the selected receiver can be changed by
pressing the SELECT button for 1 second. The next receiver will perform a brief con-
firmation run. Only one receiver can be selected at one time for moving, setting and
programming.
SELECT mode
Receiver X
Exit SELECT mode
To exit SELECT mode (the status LED will flash slowly in orange), press the SELECT
button for 3 seconds.
3 s
Status LED indicator on the transmitter for the various operating modes
Transmitter mode
Operating mode
SELECT mode
CONFIGURATION mode (only for
authorised qualified personnel),
see 5.2.7.
Power interruption/
programmed transmitter
SELECT 3 s
Receiver 1
SELECT 1 s
SELECT 1 s
Receiver 3
Indicator on status LED
Lights up when a button is pressed
Flashes slowly in orange
Flashes slowly in green or red
51
SELECT 1 s
Receiver 2
SELECT 1 s
GB
GB