GRAUPNER mx-10 Hott Manuel De Programmation page 95

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The fi rmware fi les are present in a product-speci-
fi c encoded form, i.e. if you inadvertently select a fi le
which does not match the product (e.g. transmitter
update fi le instead of receiver update fi le) the pop-up
window "Product code error" appears, and the update
process cannot be started.
If you have not already done so, switch the recei-
vers power supply OFF at this point and start the re-
ceivers update procedure by clicking on the "Down-
load Start" button. Wait until the progress bar starts
running. This can take up to several seconds. Now
switch the receiver ON with the SET-Button pressed.
After a few seconds, the status display „Found target
device ..." appears. Now release the SET-Button. The
actual update process now commences, and a pro-
gress bar starts running:
On the other hand, if the device is not recognised,
the pop-up window "Target device ID not found" ap-
pears.
If the process is interrupted before the progress bar
reaches the 100% mark, switch off your receiver po-
wer supply and carry out another attempt at the up-
date process, i.e. repeat all the steps described abo-
ve.
The Status Display and the progress bar show the
progress of the fi rmware update process. The update
is completed when the message "Download Process
Complete!!" appears.
During the update process the green LED on the re-
ceiver light up. When the update is completed, the
green LED goes out.
Switch the receiver off, and disconnect the interface
lead. If you have multiple receivers, you must repeat
the procedure with each one.
4. Initialising the receiver
Once you have completed the update process, for
safety reasons you MUST initialise the receiver befo-
re using it again:
Hold the SET button on the receiver pressed in while
you switch on its power supply; then release the SET
button again after approx. 3 sec - the green LED ex-
pires. If you now switch the transmitter on again, after
about two or three seconds the green LED on the re-
ceiver will light up constantly. However, all the other
previously programmed settings in the receiver - with
the exception of the binding information - are now re-
set to the factory default values, and you will need to
re-enter them if required.
Using the receiver for the fi rst time
95

Hide quick links:

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

33110Gr-12 hottGrp-33110.77

Table des Matières