GRAUPNER mx-10 Hott Manuel De Programmation page 85

Brake spring and ratchet
You can alter the braking force of the stick by adjusting
the outer of the two screws circled in white in the next
picture; adjusting the inner screw alters the strength of
the ratchet:
Note:
The right-hand stick unit is of mirror-image construction,
i. e. the screw you require is located on the right, below
centre.
Stick centring force
The centring force of the sticks is also variable to suit
your preference. The adjustment system is located
adjacent to the centring springs; see the white circles in
the following photo.
You can set the preferred centring spring force by
rotating the corresponding adjuster screw using a cross-
point screwdriver:
• Turn to the right = harder spring tension;
• Turn to the left = softer spring tension.
vertical vertical
horizontal horizontal
Note:
The right-hand stick unit is of mirror-image construction,
i. e. the screw you require is located on the right, below
centre.
Operating Notes 85