Fcc Information - GRAUPNER mx-10 Hott Manuel De Programmation

FCC Information

Graupner mx-10 HoTT #33110
FCC ID: Z Z-MX-10
FCC Statement
1. This device complies with Part 15C of the FCC Ru-
les. Operation is subject to the following two condi-
tions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference recei-
ved, including interference that may cause un
desired operation.
2. Changes or modifi cations not expressly approved
by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful in-
terference in a residential installation. This equipment
generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by tur-
ning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
202 FCC Information
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV tech-
nician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure
limits set forth for un uncontrolled envirionment. This
equipment should be installed and operated with a
minimum distance of 20 cm between the antenna and
your body.