ner" menu point of the multi-function menu. (The trainer
model's receiving system, previously bound to the Pupil
transmitter, does not need to be switched on during the
following procedure.):
ser vo set.
contr set.
D/R expo
phase trim
wing mixer
free mixer
ser vo disp
basic sett
fail-safe
telemetr y
teach/pupi
info disp
Press the central
SET
button of the right-hand four-way
button to open the following menu point:
TRAINER/Pupil
–P
T
1
2 3 4 5 6
SW: –––
BIND:
Press the central
SET
button of the right-hand four-way
button to release the control channels to be transferred
to the Pupil. When you do this, the corresponding sym-
bol changes from to . For example:
TRAINER/Pupil
–P
T
1 2 3 4
5
6
SW: –––
BIND:
In contrast to the wired Trainer system described in the
previous section, in which TRANSMITTER CONTROL
SIGNALS are released to the Pupil exclusively, it is
CONTROL CHANNELS which are transferred when
using the wireless HoTT system which is described in
this section.
For example, if the aileron function (2) is to be trans-
ferred, and if the model is equipped with two aileron
servos which are usually connected to receiver sockets
2 and 5, then in the wireless system control channels 2
and 5 must also be transferred. You still have to assign
a Trainer transfer switch on the right of the screen so
that you can actually transfer control to the Pupil. This is
accomplished by using the arrow buttons of the left or
right-hand four-way button to place the marker next to
"SW" at bottom right, and assign a switch.
We recommend that you use the momentary switch
SW 1 as the transfer switch, to ensure that the Teacher
transmitter can regain control instantly at any time.
TRAINER/Teach
¿
N/A
P
T
1 2 3 4 5 6
SW:
Now use the arrow buttons of the left or right-hand
four-way button to move the marker to "BIND: N/A" on
the right:
TRAINER/Teach
P
¿ T
N/A
1 2 3 4 5 6
SW:
Close the previously defi ned transfer switch ...
1
BIND:
N/A
1
BIND:
N/A
TRAINER/Teach
¿
P
T
1 2 3 4 5 6
SW:
1
BIND:
... and start the "BINDING" process by pressing the
central
SET
button of the right-hand four-way button. As
soon as this process is concluded, both screens display
"ON" instead of the fl ashing message "BINDING":
TRAINER/Teach
¿
P
T
1 2 3 4 5 6
SW: 1
BIND:
Note: even if the transmitter is turned off temporarily, the
teacher mode remains active when turned on again.
Trainer mode operations
Connect the two transmitters using the wireless Trainer
mode.
Important Note: Be sure to check all functions
BEFORE teacher-student operation for proper
change-over.
While the operation it is no problem for the Teacher and
Pupil to stand a little way apart. However, you should
never exceed a distance of 50 m (this is known as the
call range), and no other persons should stand between
Program description: Trainer system
N/A
ON
129