GRAUPNER mx-10 Hott Manuel De Programmation page 93

RX CURVE
CURVE1 CH : 02
TYPE :
CURVE2 CH : 05
TYPE :
CURVE3 CH : 04
TYPE :
5CH FUNCTION:SENSOR
A further press of the INC+DEC buttons concludes your
choice.
Concluding notes:
• The much higher servo resolution of the HoTT sys-
tem results in a substantially more direct response
compared with previous technologies. Please take a
little time to become accustomed to the fi ner control
characteristics offered by the system!
• If you wish to use a speed controller with integral
BEC* system in parallel with a separate receiver bat-
tery, in most cases (depending on the speed control-
ler) the positive terminal (red wire) must be removed
from the three-pin connector, as shown in the dia-
gram. Be sure to read the appropriate notes in the in-
structions supplied with your speed controller befo-
re doing this.
Carefully raise the central lug of the connector slight-
ly (1), withdraw the red
wire (2) and insulate the 1
bare contact with tape
to avoid possible short
circuits (3).
Observe the installation notes regarding the recei-
ver, receiver aerial and servos, which you will fi nd on
page 96.
* Battery Elimination Circuit
Reset
If you wish to carry out a receiver reset, locate the
A
button on the top of the receiver and hold it in while you
connect its power supply; release the button again.
A
If the reset is carried out with the transmitter switched
B
off, or if the receiver is not already bound, the receiver
LED fl ashes red slowly after about two or three seconds;
at this stage it is immediately possible to initiate a
binding process at the transmitter. If the reset is carried
out with an already bound receiver, if the transmitter
is switched on, and if the associated model memory is
active, then the LED lights up green after a short interval
to indicate that your transmitter / receiving system is
ready for use once more.
Please note the following:
Resetting the receiver resets ALL the settings
stored in the receiver to the default settings, with
the exception of the binding information! If you
carry out a reset by mistake, this means that you
will have to restore all the receiver settings entered
using the Telemetry menu.
On the other hand, a deliberate RESET is particu-
larly useful if you wish to "re-house" a receiver in a
different model, as it represents an easy method of
avoiding the transference of unsuitable settings.
red
3
2
SET
Using the receiver for the fi rst time 93