6.1.6.2 Test function menu
A diagnostic menu is available to conduct
operational tests on the device.
It allows you to configure the following parameters:
Enable the Wiper: Allows users to enable the
1.
wiper.
2.
Enable Night Mode: Enables night mode
activation in continuous mode.
3.
Enable the Relay: Allows users to enable the
relay.
4.
Device reboot: Allows users to reboot the
device.
5.
I/O status: Allows access to the l/O status
menu.
TEST FUNCTIONS
TEST FUNCTIONS
------------------------
------------------------
1>WIPER START
1>WIPER START
2>NIGHT MODE ON
2>NIGHT MODE ON
3>RELAY ON
3>RELAY ON
4 DEVICE REBOOT
4 DEVICE REBOOT
5 I/O STATUS
5 I/O STATUS
Fig. 40
26
6.1.6.2.1 I/O status menu
This menu displays the status of certain device
components (useful for diagnostic functions).
Input alarm: Displays the alarm status (enabled or
disabled).
Dip In: Displays the status of the control board dip-
switch.
Relay: Displays the relay status (enabled or
disabled).
Wiper: Displays the wiper status (enabled or
disabled).
Camera Power Supply: Displays the camera status
(enabled or disabled).
I/O STATUS
I/O STATUS
------------------------
------------------------
ENTRY ALARM
ENTRY ALARM
DIP IN
DIP IN
: N
: N
RELAY
RELAY
: N
: N
WIPER
WIPER
: Y
: Y
CAMERA POWER
CAMERA POWER
: Y
: Y
>
>
Fig. 41
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 1
: 1
MNVCMVXTCAM_2121_EN