6.1.5 Display Menu
It allows you to configure the following parameters:
Received Commands: If not on OFF, it is used
1.
to select how the received serial commands are
displayed. It is possible to select timed (1s, 3s
and 5s) or constant (CONST) display.
2.
Alarms: When not switched to OFF, this is
used to select the display mode for the alarms.
It is possible to select timed (1s, 3s and 5s) or
constant (CONST) display.
DISPLAY
DISPLAY
------------------------
------------------------
1>RECEIVED COMMAND:CONST
1>RECEIVED COMMAND:CONST
2 ALARMS
2 ALARMS
Fig. 37
6.1.6 Options Menu
It allows you to configure the following parameters:
Alarms: Allows access to the Alarms menu.
1.
Washer: Allows access to the Washer menu.
2.
Test functions: Allows access to the Test
3.
Functions menu.
Communications: Allows access to the
4.
Communications menu.
Ceiling Mount: Flip the image.
5.
OPTION
OPTION
------------------------
------------------------
1>ALARMS
1>ALARMS
2 WASHER
2 WASHER
3 TEST FUNCTIONS
3 TEST FUNCTIONS
4 COMMUNICATIONS
4 COMMUNICATIONS
5 CEILING MOUNT:
5 CEILING MOUNT:
Fig. 38
MNVCMVXTCAM_2121_EN
6.1.6.1 Alarms Menu
From the Alarms menu, users can access the Alarm 1
menu and change the settings.
It allows you to configure the following parameters:
1.
2.
3.
:
:
OFF
OFF
Fig. 39
The menu dynamically auto-configures based on the
camera installed and the choice made, showing the
parameters on which you can act.
>
>
>
>
>
>
>
>
N
N
Type: Set the type of contact: normally closed
(N.C.) or normally open (N.O.).
Action: The type of action carried out by the
unit when the alarm triggers (Relay, Washer,
Wiper). If Off is selected, the alarm is disabled.
Text: It is possible to set the wording displayed
when the alarm is enabled.
ALARM 1
ALARM 1
------------------------
------------------------
STATUS
STATUS
:
:
1>TYPE
1>TYPE
:
:
2 ACTION:
2 ACTION:
3 TEXT
3 TEXT
:
:
OPEN
OPEN
N.O.
N.O.
OFF
OFF
ALARM
ALARM
25