Fitting The Barcode Scanner Bracket (Seca 797); Disinfecting The Device; Transporting And Setting Up The Device; Transporting The Device - Seca 787 Mode D'emploi Et Garantie

Fitting the barcode scanner bracket

4.4 Disinfecting the device

4.5 Transporting and setting up the device

Transporting the device

NOTE
(seca 797) For measuring stations with the
ner bracket available as an option is required (➔ "Optional accesso-
ries and spare parts (seca 797)", page 41). The scanner bracket from
the scope of delivery for the measuring station cannot be used. Follow
the assembly instructions for the
seca 436
The barcode scanner bracket can be fitted to either side of the display head.
It can be fitted offset by 90° to point forwards, sideways or backwards.
1. Put the barcode scanner bracket in the desired position.
2. Fit the barcode scanner bracket to the display head using a cross-head
screw.
► Disinfect the following components before initial commissioning
(➔ "Disinfecting", page 36):
– Column and recessed handle
– Display head and display unit
– Measuring rod, head slide with measuring flap
– Weighing platform
– Handrail (optional accessory)
The device is equipped with two casters to facilitate transport over short
distances.
1. If necessary, remove the plug-in power supply unit from the power socket
and from the device.
2. Fold down the measuring flap and push the upper telescopic element of
the measuring rod into its lowest position.
3. Take hold of the recessed handle of the device.
CAUTION!
Injury from device falling over
► Ensure that you have a firm hold of the device when transporting it.
4. Tilt the device until it can be moved freely on the casters.
5. Move the device slowly and carefully over door sills.
6. Transport the device to its new setup location.
seca 477
seca 477
scanner bracket.
English
handrail, the scan-
seca 436
handrail and for the
Starting up device • 23