Switching The Positions Of The Display Unit And The Battery Compartment - Seca 787 Mode D'emploi Et Garantie

Switching the positions of the
display unit and the battery
Left-hand Right-hand
operating side operating side
9.
seca 797
10. Set the measuring station in an upright position.
11. Remove the protective film from the display (if desired).
At the factory, the display unit is fitted to the right-hand operating side of the
display head. The battery compartment is on the left-hand operating side.
compartment
Proceed as follows to switch the positions of the display unit and the battery
compartment.
1. Remove the cover panel:
2. Remove the battery compartment lid:
3. Remove the display unit:
only: Connect the display cable:
a) Draw the display cable out of the column
b) Plug the display cable into the labeled socket
c) Fix the display cable in position with the cable clip
a) Unscrew two cross-head screws
b) Remove the cover panel
a) Hold the battery compartment lid steady
b) Remove the cross-head screw behind the battery compartment lid
c) Remove the battery compartment lid
a) Undo the cross-head screw behind the display unit
b) Remove cable tie on the cable hook and strain relief, if present
c) Draw cables out of the cable hook
d) Lift off display unit
English
Starting up device • 21