(Ahold); Setting Permanent Display Of Weight Value (Hold); Setting Filtering (Fil); Setting Standby Time (Aoff) - Seca 787 Mode D'emploi Et Garantie

Setting permanent display of weight

Setting filtering (FIL)

Setting standby time (AOFF)

34 •
1. Select the
2. Confirm your selection.
The current setting is displayed.
3. Select the desired setting:
4. Confirm your selection.
You exit the menu automatically.
If the
Autohold
value (HOLd) weight value is displayed permanently. You can set when the display of
weight value is automatically cleared again.
1. Select the
2. Confirm your selection.
The current setting is displayed.
3. Select the desired setting:
4. Confirm your selection.
You exit the menu automatically.
Filtering reduces interference (due to patient movement, for example) when
measuring weight. You can modify the strength of filtering.
1. Select the
2. Confirm your selection.
The current setting is displayed.
3. Select a filtering level:
4. Confirm your selection.
You exit the menu automatically.
In battery operation, the measuring station remains on standby for 30 sec-
onds (factory setting). If there is no input or no load is put on the weighing
platform during standby time, the measuring station switches off automati-
cally. Measuring results will be discarded.
You can adjust standby time as follows:
1. Select the
2. Confirm your selection.
The time currently set is displayed (in this case: 30 seconds).
3. Select the desired time:
4. Confirm your selection.
You exit the menu automatically.
item from the menu.
AHOLd
–
On
–
OFF
function is activated or you have pressed the 
item from the menu.
HOLd
– : A new load on the measuring station clears the display
HOLd 1
value
– : Removing the load from the measuring station clears the
HOLd 2
display value
item from the menu.
FIL
– : Low filtering
0
– : Moderate filtering
1
– : High filtering
2
Function
Factory setting
Increment
Minimum standby time
Maximum standby time 600 seconds (10 minutes)
item from the menu.
AOFF
► To increase value: Press 
► To reduce value: Press 
Setting
30 seconds
30 seconds
30 seconds
key
Hold
key
BMI
key, the
Hold