Fitting The Display Head - Seca 787 Mode D'emploi Et Garantie

Fitting the display head

20 •
5. Tighten the screws using the T20 hex key supplied (recommended
tightening torque: 3 Nm).
6. Set the measuring station in an upright position.
Proceed as follows to fit the display head to the column.
1. Extend the upper telescopic element of the measuring rod approx.
10 cm.
2. Guide the cable(s) of the display head through the center channel of the
column as far as the lower part of the device.
NOTE
One or two cables will be present, depending on the model:
• Connecting cable (
• Connecting cable and display cable (
3. Put the display head on the column.
4. Push the upper telescopic element into its lowest position.
5. Place one cross-head screw in each of the two side bores of the column.
6. Tighten the cross-head screws.
7. Place the measuring station on the floor with the display unit facing
upward.
NOTICE!
Damage due to assembly faults
If the cables are bent at too sharp an angle, they may be damaged
and thus cause a functional failure.
► Route all cables to prevent sharp bends and kinked connectors.
8. Connect the connecting cable:
a) Draw the connecting cable out of the column
b) Route the connecting cable past the cable clip and insert in the
socket on the weighing platform
c) Fix the connecting cable in position with the cable clip
)
seca 787
seca 797
)