Setting Up The Wifi Connection (Seca 797); Setting The Wifi Function - Seca 787 Mode D'emploi Et Garantie

4.8 Setting up the WiFi connection (seca 797)

Setting the WiFi function

Connecting the device to the WiFi
26 •
2. Connect the barcode scanner:
3. Hang the barcode scanner in the barcode scanner bracket.
4. Fit the cover panel:
1. Switch on the measuring station (➔ "Switching on the device", page 27).
2. Select the
3. Confirm your selection.
4. Select the
5. Confirm your selection.
The current setting is displayed.
6. Select the desired setting:
On
OFF
PErM
7. Confirm your selection.
You exit the menu automatically.
Connect your device to the WiFi network via WPS if you have access to the
network (WPS) WiFi router.
1. Select the
2. Activate the WPS function of your WiFi router as described in the
instructions for use for your WiFi router.
a) Plug the USB connector of the barcode scanner into the USB
interface of the display unit
b) Route the barcode scanner cable over the strain relief
NOTE
Some barcode scanner cables are very thin and are thus not
adequately held in place.
► Additionally fix the barcode scanner cable in the bores on the strain
relief using a cable tie.
a) Insert cover panel
b) Place and tighten 2 cross-head screws
menu item (➔ "Navigating in the menu", page 33).
rF
menu item.
SYS
Option
WiFi function is activated with power supply
operation, is deactivated with battery operation
WiFi function deactivated
WiFi function is activated with power supply
operation and battery operation (leads to
increased power consumption in battery
operation)
menu item (➔ "Navigating in the menu", page 33).
rF
Effect