Connecting The Plug-In Power Supply Unit (Variant-Dependent); Connecting The Barcode Scanner (Seca 797) - Seca 787 Mode D'emploi Et Garantie

Connecting the plug-in power
supply unit (variant-dependent)

4.7 Connecting the barcode scanner (seca 797)

The seca plug-in power supply unit is included in the scope of delivery or is
available as an optional accessory depending on variant.
WARNING!
Personal injury or damage to the device as a result of incorrect power
supply units
Conventional power supply units may deliver a higher voltage than is
indicated on them. The measuring station may overheat, catch fire,
melt or short-circuit.
► Use only original seca plug-in power supply units with controlled
12 V output voltage.
The connection for the plug-in power supply unit is located on the side of the
column holder. To establish the power supply, proceed as follows:
1. Insert the connector plug of the plug-in power supply unit into the power
supply connection socket of the measuring station.
2. Plug the plug-in power supply unit into a power supply socket.
A barcode scanner can be connected to the USB interface of the measuring
station. The barcode scanner can be used to record the ID of the patient and/
or the ID of the user.
NOTE
• If you want to use the WiFi function or a barcode scanner (variant-
dependent), the power consumption of the device rises significantly.
In these cases, operate the device with the plug-in power supply
unit provided.
• Observe the maximum permitted current consumption of the
barcode scanner (➔ "General technical data", page 39).
• Use only barcode scanners recommended by seca (➔ "Optional
accessories and spare parts (seca 797)", page 41).
To connect a barcode scanner to the display unit, proceed as follows.
1. Remove the cover panel:
a) Unscrew 2 cross-head screws
b) Remove the cover panel
English
Starting up device • 25