Operation; Setup; Adjusting The Trigger Tension - WAGNER LineCoat 800 Mode D'emploi

3.

Operation

This equipment produces a fluid stream at extremely
high pressure. Read and understand the warnings
in the Safety Precautions section at the front of this
manual before operating this equipment.
3.1

Setup

Perform the following procedure before starting the engine of a gas-
powered line striper.
1. Ensure that the siphon hose and the return hose are attached
and secure.
2. Position the spray gun (fig. 2).
a. Loosen the support bar clamp hex screw (1) and rotate the
gun support bar (2) to the desired position. Tighten the hex
screw securely.
b. Loosen the gun holder clamp knob (3) and slide the spray
gun to the desired vertical and horizontal (front-to-back)
position. Tighten the knob securely.
1
3
3. Turn the pressure control knob fully counterclockwise to its
lowest pressure setting (fig 3, 1).
4. Make sure the pump ON/OFF switch is in the OFF position (fig
3, 2).
1
i The height of the spray gun affects the width of the
spray pattern (i.e., the lower the gun, the smaller the
line width). Tip size also affects line width.
Never operate unit for more than ten seconds
without fluid. Operating this unit without fluid will
cause unnecessary wear to the packings.
Attention
5. Check the engine oil level. The gasoline engine oil level
is determined by the manufacturer. Refer to the engine
manufacturer's service manual (supplied).
6. Close the fuel shut-off lever and fill the gas tank with gasoline.
Use only high quality, unleaded gasoline.
LineCoat 800
GB
i
a. Remove the support bar clamp hex screw and nut.
b. Move the gun support bar to the opposite side of the cart.
c. Align the support bar clamp with the bracket on the cart.
d. Thread the clamp hex screw through the gun support bar
3.2
Use the following procedure to adjust the spring tension of the
trigger lever on the gun holder assembly. The trigger lever pulls and
releases the spray gun trigger when operated from the trigger on the
cart. The proper tension ensures that the gun will shut off when the
gun trigger is released. To ensure proper tension, there should be
approximately a 1/32" to 1/16" gap between the trigger lever and the
spray gun trigger.
Attention
1. Using a wrench, loosen the bolt on the cable block (1).
2
2. Move the cable block in the appropriate direction to create
2
3. Tighten the set screw securely.
21
The gun support bar and the spray gun can be
mounted on either side of the sprayer. To move the
gun support bar:
clamp and the bracket on the cart. Place the nut on the end of
the clamp hex screw and tighten securely.
Adjusting the trigger tension (fig. 4)
Always keep the trigger lock on the spray gun in the
locked position while making adjustments to the
system.
a gap of 0.8 mm to 1.6 mm between the trigger lever (2) and
spray gun trigger (3).
a. Slide the cable block toward the gun to increase the gap
between the trigger lever and spray gun trigger.
b. Slide the cable block away from the gun to decrease the gap
between the trigger lever and spray gun trigger.
1
3
0.8 - 1.6 mm
Operation
2