Painting - WAGNER LineCoat 800 Mode D'emploi

Operation
Earth the gun by holding it against the edge of the
metal container while flushing. Failure to do so may
lead to a static electric discharge, which may cause
a fire.
16. Trigger the gun into the metal waste container until the old
solvent is gone and fresh solvent is coming out of the gun.
17. Lock the gun by turning the gun trigger lock to the locked
position.
18. Set down the gun and increase the pressure by turning the
pressure control knob slowly clockwise to its highest setting.
19. Check the entire system for leaks. If leaks occur, turn the
sprayer off and follow the "Pressure Relief Procedure" in this
manual before tightening any fittings or hoses.
20. Follow the "Pressure Relief Procedure" (section 4.2) in this
manual before changing from solvent to paint.
Be sure to follow the Pressure Relief Procedure when
shutting the unit down for any purpose, including
servicing or adjusting any part of the spray system,
changing or cleaning spray tips, or preparing for
cleanup.
LineCoat 800
GB
4.

Painting

1. Place the siphon tube into a container of paint.
2. Place the return hose into a metal waste container.
3. Turn the pressure control knob fully counterclockwise to its
lowest pressure setting.
4. Move the PRIME/SPRAY valve to the PRIME position.
5. Move the engine ON/OFF switch to the ON position.
6. Start the engine (fig. 8):
a. Open the fuel valve lever (2).
b. Move the throttle lever away from the gas tank (3).
c. Close the engine choke lever (4).
d. Holding the frame with one hand, pull the starter rope (5)
rapidly and firmly. Continue to hold the rope as you let it
return. Pull and return the rope until the engine starts.
7. Turn on the sprayer by moving the pump ON/OFF switch to
the ON position (fig 9, 1).
8. Slowly turn the pressure control knob (fig. 9, 2) clockwise
to increase the pressure until fluid starts to come out of the
return hose. Use only enough pressure to keep the fluid
coming out.
1
9. Allow the sprayer to run until paint is coming through the
return hose into the metal waste container.
10. Turn the pressure control knob fully counterclockwise to its
lowest setting.
11. Turn off the sprayer by moving the pump ON/OFF switch to
the OFF position.
12. Remove the return hose from the waste container and place it in
its operating position above the container of paint.
13. Move the PRIME/SPRAY valve to the SPRAY position.
14. Turn on the sprayer.
15. Turn the pressure control knob slowly clockwise to increase
pressure.
16. Unlock the gun by turning the gun trigger lock to the
unlocked position.
23
3
4
1
2 5
Painting
2