High Voltage Wiring Connections - Franklin Electric SubDrive 15 Manuel Du Propriétaire

INSTALLATION AND SETUP
Electrical Installation

High Voltage Wiring Connections

Contact with hazardous voltage could result in death or serious injury.
• Disconnect and lock out all power before installing or servicing equipment.
• Connect the motor, the SubDrive/MonoDrive, metal plumbing, and all other metal near the
motor or cable to the power supply ground terminal using wire no smaller than motor cable
wires.
• Install and wire in accordance with all applicable local and national electrical construction
codes.
Ground Connections
Risk of damage to drive
• Ensure that the system is properly grounded all the way to the service entrance panel.
Improper grounding may result in loss of voltage surge protection and interference filtering.
Follow these grounding requirements to ensure safety and performance.
1. Make sure a service entrance ground rod is properly installed and connected.
2. Service Entrance Panel.
3. An input power ground wire from the supply panel must be connected to the drive.
4. A dedicated output ground wire from the drive must be connected to the motor. Motor and
ground wires must be bundled together.
22
,
or malfunction can occur.