Installation And Setup; Installation Process - Franklin Electric SubDrive 15 Manuel Du Propriétaire

INSTALLATION AND SETUP

Installation Process

Refer to the following table when planning installation of the SubDrive/MonoDrive Connect.
1
Plan System Identify
Goals Options
Intended Function Automation
• Constant • Bump mode
pressure water • Steady Flow
systems • Drawdown
• Pressure
Protection
Boosting
• Overload
Hardware
• Underload
Application
• Motor Ground
• Submersible
• Surface pump • Moisture Sensor
• Single- or • Drive
Three-Phase
Multi-Pump
• Duplex
• Lead/Lag
1. The planned usage of the overall system will determine which options and control methods
are appropriate, as well as how the VFD should be installed and programmed. Refer to the fol-
lowing pages for examples of how the system might be used.
2. System options define and automate features that support the intended operation. These fea-
tures may require specialized control methods and programming. For more details, refer to
"Drive Configuration" on page
3. The SubDrive/MonoDrive Connect supports several methods for automating pump motor
speed control. Refer to
4. The overall function of the system directly affects where and how the VFD should be mounted.
Refer to "Physical Installation" on page 17
5. The selected motor application, along with the control method(s), determines how the VFD
should be connected. Refer to
6. The VFD can be quickly and easily programmed for most standard operations. Refer to
Configuration" on page
to achieve the desired performance. Refer to
to "Drive Configuration Using the FE Connect App" on page
2 3
Select Control
Methods
Pressure Feed-
back Type
• Transducer
• Pressure Sensor
Switches
• Float
• On/Off
Potentiometer
Fault
• Setpoint value
• Underload
Sensitivity
Temperature
Communications
• Drive-to-drive
• Aux Input
Alternator
26, and "Advanced Application Options" on page
"Drive Configuration" on page 26
for guidelines.
"Electrical Installation" on page 19
26. Advanced features or options may require additional adjustments
4
Install VFD
Hardware
Location
• Inside
• Outside
Climate control
• Temperature
• Moisture
Distance
• Wire sizes
• Filtering
requirements
Measurements
• Clearance
• Drilling
for possible control setups.
for more information.
"Advanced Application Options" on page 41
36.
INSTALLATION AND SETUP
Installation Process
5
Install Wiring Program
Parameters
Conduit Basic
• Routing • Application
• Separation • Motor ratings
• Setpoints
High Voltage
I/O setup
• Grounding
• Inputs • Input functions
• Outputs • Output
functions
Control circuits
Option settings
• Feedback
inputs • Enable features
• Relay outputs
• Communications
41.
"Drive
and
6
13