Franklin Electric SubDrive 15 Manuel Du Propriétaire page 9

Single-Phase (3-Wire) Submersible Applications
Motor and Pump Combinations
0.5 hp (0.37 kW) 214505-series motor with:
• 0.5 hp (0.37 kW) pump
0.75 hp (0.55 kW) 214507-series motor with:
• 0.75 hp (0.55 kW) pump
1.0 hp (0.75 kW) 214508-series motor with:
• 1.0 hp (0.75 kW) pump
1.5 hp (1.1 kW) 224300-series motor with:
• 1.5 hp (1.1 kW) pump
2.0 hp (1.5 kW) 224301-series motor with:
• 2.0 hp (1.5 kW) pump
3.0 hp (2.2 kW) 224302-series motor with:
• 3.0 hp (2.2 kW) pump
Note: SubDrives can operate as a MonoDrive.
SubDrive Connect Models with Surface Motor Capacity Ratings
SubDrive Connect models will operate many Franklin Electric surface mounted pumps, including
VR, MH, BT4, and DDS series.
NOTE: Recommended for use on inverter duty rated motors. Follow motor manufacturer recom-
mendations for cable lengths when using variable frequency drives.
When operating a surface system, drives are configured based on motor current capacity rather
than horsepower. Motor current capacity is programmed through DIP switch settings. Refer to
"Surface Motor Overload (Size) and System Response (DIP SW2 & DIP SW3)" on page
Model
SubDrive15
SubDrive20
SubDrive30 2.0 – 10.9 A, 230 VAC three-phase
SubDrive50
Note: Using the FE Connect Mobile App, motor overload current can be set from 2.0 A up to the
max current rating of the drive model in 0.1 A increments. Refer to
FE Connect App" on page
SubDrive
Current Capacity
2.0 – 5.9 A, 230 VAC three-phase
2.0 – 8.1 A, 230 VAC three-phase
2.0– 17.8 A, 230 VAC three-phase
36.
SubDrive SubDrive
50 30 20
 
 
 
 
 

"Drive Configuration Using the
PRODUCT INFORMATION
SubDrive MonoDrive
15 XT
  
  
  
 
 
27.
Applications
MonoDrive



9