Standard Submersible Constant Pressure System - Franklin Electric SubDrive 15 Manuel Du Propriétaire

INSTALLATION AND SETUP
Installation Process

Standard Submersible Constant Pressure System

The above drawing illustrates how a typical submersible pump system should be arranged for a
constant pressure application.
1. Pump and Franklin Electric Motor. Refer to the Franklin Electric AIM Manual for pump, pipe,
and cable sizing information.
2. Check Valve
3. Pressure Relief Valve: Pressure relief valve must be able to pass full pump flow at 100 PSI.
Risk of bodily injury or property damage.
• Pumps can develop very high pressure in some situations. Always install a pressure relief
valve able to pass full pump flow at 100 psi.
• Install the pressure relief valve near the pressure tank and route to a drain capable of full sys-
tem flow.
4. Pressure Tank: Refer to
5. Pressure Gauge
6. Pressure Transducer or Sensor: Install in a vertical position.
7. SubDrive/MonoDrive Connect VFD
8. Power Supply from Circuit Breaker. Single phase, 208/230 VAC +/- 10%.
9. Power to Motor: Single phase or Three-Phase (except MonoDrive).
A tank tee is recommended for mounting the tank, pressure transducer, pressure gauge, and pres-
sure relief valve. If a tank tee is not used, the pressure transducer or pressure sensor should be
within 6 feet (1.8 meters) of the pressure tank to minimize pressure fluctuations. There should be
no elbows between the tank and pressure transducer or pressure sensor.
14
"Minimum Pressure Tank and Supply Pipe Sizing" on page 16.