Drive Mounting - Franklin Electric SubDrive 15 Manuel Du Propriétaire

Masquer les pouces Voir aussi pour SubDrive 15:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION AND SETUP
Physical Installation

Drive Mounting

The SubDrive/MonoDrive should be mounted on a surface or backplate no smaller than the outer
controller dimensions in order to maintain the NEMA 3R rating. The controller must be mounted at
least 18" (45.7 cm) off the ground.
The drive is mounted using the hanging tab on the top side of the enclosure, as well as two (2)
additional mounting holes on the back side. All three (3) screw hole locations should be used to
ensure the drive is securely mounted.
IMPORTANT: Do not drill holes in the drive.
Model
"A"
SubDrive 15,
464.2 mm
(18.28 in)
MonoDrive
SubDrive 20,
539.4 mm
(21.24 in)
SubDrive 30,
MonoDrive XT
SubDrive 50
539.4 mm
(21.24 in)
18
"B"
"C"
355.2 mm
454.7 mm
(13.98 in)
(17.90 in)
430.4 mm
529.9 mm
(16.94 in)
(20.86 in)
430.4 mm
529.9 mm
(16.94 in)
(20.86 in)
"D"
"E"
427.4 mm
157.4 mm
(16.83 in)
(6.19 in)
502.6 mm
157.4 mm
(19.79 in)
(6.19 in)
416.2 mm
168.4 mm
(16.39 in)
(6.63 in)

Publicité

Table des Matières
loading

Table des Matières