Burkert 8071 Manuel Utilisateur page 27

Problem Cause
No frequency output Wrong wiring of the transistor or
the Reed switch
Rotors mounted on a wrong way
Magnet damaged
Hall sensor or Reed switch
damaged
20
Do the following
→
→
→
→
english
Make sure that the device has been wired correctly (see chap.
wiring).
Dismantle the sensor and modify the position of the rotors (see chap.
mantle the sensor and chap. 9.5. Assemble the sensor).
Replace the rotors (see chap.
Dismantle the sensor and chap. 9.5. Assemble the sensor).
Replace the cover (see chap.
Dismantle the sensor and chap. 9.5. Assemble the sensor).
Type 8071
Maintenanceandtroubleshooting
10. Spare parts and accessories, chap. 9.4.
10. Spare parts and accessories, chap. 9.4.
7.3. Electrical
9.4. Dis-