Ec Declaration Of Conformity - KSB AU Manuel D'instructions

Table des Matières

Les langues disponibles

KSB ITUR undertakes:

To repair or replace at any of its ASSOCIATED TECHNICAL SERVICE CENTRES or at its factory in Zarautz, free of charge and for a period of

12 months as of the date of dispatch from our warehouses, any product which shows manufacture defects. This warranty will be reduced to 6

months for continuous or permanent operation pumps. This warranty does not include any pieces which are liable to experience deterioration

through the envisaged use of the product. The instructions set out in the maintenance and operation manual for the equipment must be fulfilled

in order to prevent excessive wear and tear.

Whenever the equipment or pumps supplied by KSB ITUR are to be used prior to installation, in such a manner as they require handling,

assembly and adjustment either before or after installation by parties other than KSB ITUR, KSB ITUR shall not be liable for any defects in the

equipment following installation unless the purchaser is able to legally prove that these defects existed prior to installation and assembly.

KSB ITUR shall in no case be liable for any direct or indirect damage which the Product may suffer as a result of defective installation, incorrect

storage, lack of maintenance, negligent handling, handling by unauthorised personnel, overloading or deficient functions, or for any damages

resulting from external influences such as chemical, electrochemical and electrical agents. The responsibility of KSB ITUR is limited in all cases

to the replacement, as speedily as possible, of the defective part, without it being in any way liable for other responsibilities or compensation.

KSB ITUR Spain, S.A., with address in footer

PUMP SERIES: AU

S/N: 997242000000 000000 – 998000000000 000000

KSB ITUR hereby declares, under its responsibility, that its aforementioned

machine, to which this Declaration refers, is in conformity with the

applicable provisions of the following Directives:

Machinery: 2006/42/EC

Applied harmonised standards: ISO 12100, EN 809

The collection of relevant technical documentation will be made in the

address in the footer

WARRANTY