Restoring Factory Settings - TERMA WEBL1K906F Mode D'emploi

③ Press
to confirm. The new code is now saved.
④ Press again on
to exit setting PIN code mode and
go back to the home display of the installer settings.
To exit the Installer settings, press

RESTORING FACTORY SETTINGS

If the PIN code protection is disabled, the user and installer
settings are re-initialized:
① From the PIN code setting, press
briefly on the display.
② N O appears. Press
yes = Factory settings reset
NO = Factory settings not reset
68
twice.
. rest appears
or to select YES.
③ Press the key
for 5 seconds. The device returns
to its initial configuration and goes back automatically
to the home display of the installer settings.
The following parameter values will be effective:
Settings
Operation
Comfort setting temperature
Boost duration
Keypad lock
User settings
Backlighting
Eco mode temperature lowering-level
Frost protection temperature
Super Comfort
Minimum set of Comfort setting
temperature
Maximum set of Comfort setting
temperature
Maximal Boost duration
Maximum ambient temperature for
the automatic stop of the Boost
Temperature unit
Installer settings
Automatic open window detection
Presence detection
Dual optimization feature
PIN code protection
Value of the PIN code
To exit the Installer settings, press
5 sec.
Factory settings
19°C
60 min.
Disabled
L3
-3,5°C
7°C
Enabled
7°C
30°C
60 min.
35°C
°C
Enabled
Enabled
Opti comfort
Disabled
0000
twice.