Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7-DAY AND DAILY PROGRAM INTEGRATED, ENERGY
SAVINGS
AUTOMATIC PROGRAMMING WITH
SELFLEARNING PROCESS
OVERVIEW
Auto-programming (Auto): After an initial learning period
of one week, the device will analyze occupancy cycles to
determine and implement a weekly program adapted to
your lifecycle alternating periods in comfort and periods
in eco, the goal being to deliver the most efficient yet
comfortable and user focused heating cycle. The product
algorithm will continually learn and adapt to changes in
your presence patterns, adapting week and optimizing
the heating program to these changes.
OPERATING
Upon the first activation
of your device, the mode
«auto-program» is activated
by default, in mode Auto.
To deactivate and change
the program, see Select-
ing and operating programs
page 55.
The first week of operation
is a learning week during
which the device memorizes
your habits and elaborates
a program for the week.
Therefore, it defines a program consisting of Comfort
and Eco periods, independently for each day of the week.
During this ʻlearning weekʼ, the device will temporarily
operate in the permanent «Comfort» mode.
Important: To ensure the auto-programming is optimized,
please ensure the presence detection sensor is not inter-
fered by an external source, see important information
concerning the presence detection system on page 65.
APPLICATION OF THE INTELLIGENT PROGRAM
One week after switching on, the device will apply the
new program for the next 7 days. Then week after week
the device will continue to optimize the intelligent pro-
gram «Auto», adjusting the Comfort and Eco periods to
fit closely to your lifestyle.
When the product is in Frost protection mode or in standby
mode for more than 24 hours, learning and optimization
of the intelligent program stops: the device stores the
previously recorded program from the last week before
switching to the Frost protection or standby mode.
— Example 1 : If the product is installed in mid-season
3
Example of display
in Comfort period
— Example 2 : You select frost protection mode before
In the case of control by pilot wire coming from an energy
3
manager for example, the pilot wire will take precedence
Exemple d'affichage
over the AUTO program which results from the Self-learn-
en période Éco
ing algorythm.
7 DAY AND DAILY PROGRAM
In this mode, you have the option of programming your
device, by setting one of the five programs on offer for
each day of the week.
ACCESS TO THE PROGRAMMING MODE
From Auto, Comfort, Eco or Frost protection mode, press
or if its installation is anticipated on the construction
site, it can be switched on in standby mode. When
you select the Auto mode, the learning week will start
automatically. The device will be in permanent comfort
and will memorize your habits to apply the adapted
program the following week.
going on holiday. Upon your return, when you return
to Auto mode, the unit will automatically apply the
previously stored intelligent program from the last
week before you left.
or 5 seconds to enter into the programming mode.
53
EN
Publicité
Table des Matières
