Installer Settings; Access; Configuration Of Detection Modes - TERMA WEBL1K906F Mode D'emploi

THE INSTRUCTIONS LISTED BELOW APPLY TO ADVANCED DEVICE SETTINGS AND SHOULD ONLY BE PERFORMED
BY QUALIFIED PERSONNEL. ENTERING INCORRECT SETTINGS MAY CAUSE THE DEVICE TO MALFUNCTION.

INSTALLER SETTINGS

ACCESS

To access the Installer settings in 4 steps, enter the Auto, Comfort, Eco or Frost protection mode, then:
Information display
1
1
Press for
5 seconds
Setting sequence:
Configuration of detection modes → Dual optimization feature → PIN code lock → Restoring factory settings
CONFIGURATION OF DETECTION
MODES
OPEN WINDOW DETECTION, ACTIVATION / DE-
ACTIVATION OF THE AUTO MODE
The automatic mode enabled is the default setting.
① Press
or .
On = automatic mode enabled.
O FF = automatic mode disabled.
Information display
2
1
Press
briefly twice
② To save and move automatically to the next setting,
PRESENCE DETECTION, ACTIVATION /
DEACTIVATION
① The presence detection enabled is the default setting.
② Press
InSt = Installer settings
3
Press for 10
seconds
press . To exit the user settings, press
or .
on = presence detection enabled.
off = presence detection disabled.
4
Press
briefly
3 times.
65
EN