Failures - Dibo JMB-S Mode D'emploi

Operate to the right: navigate to the next operation menu (at each other
screen, same principle). At the top right, the current temperature is visualized
and at the top left the burner indication.
3 C O N T R O L S C R E E N - E N G I N E S P E E D S E T T I N G ( O P T I O N AT J M B - S - W )
In this screen you can set the desired engine speed.
The basic setting at the start is set at 50%. Move the control stick upwards
(increase speed) or downwards (lower speed) below to set the desired
engine speed. Increase/decrease in steps of 10%. Minimum value 0% - max.
value 100%. At the top right, the current pressure is visualized.
Pay attention: If the key contact is put into position
"ON" , the engine speed is not adjustable. Start the key
contact by before the engine speed is adjustable!
4 C O N T R O L S C R E E N - L I G H T I N G ( O P T I O N )
In this screen you can set the lighting. Move the control stick upwards (work
light on/off) or downwards (beacon light on/off) to set the desired condition.
Push the control stick to activate, push again to deactivate.
5 C O N T R O L S C R E E N - F I L L I N G P U M P ( O P T I O N )
In this screen you can turn on / off the filling pump.
Move the control stick upwards (turn on) or downwards (turn off).
2

Failures

The screen includes a number of failures like indicated on this page.
When service is necessary, also a message will appear.
During dry- running of the water tank, the burner will first turn off, afterwards the
machine will shut down -> cooling down process.
Pay attention: this screen always appear if there will be
switched from position 0 to 1 (via key contact) when the
required service period is necessary. Move the control stick
to the left to remove the message from the display.
DiBO 27
E N
O P E R AT I O N