Dibo JMB-S Mode D'emploi page 115

19 R E E L
The JMB-S will be standard equipped with a high pressure reel.
Always secure/block the reel after use and before transporting the trailer!
- - - - - - - - - - - - - - - - - - - - - - - - - -
Please note for possible risk of heat to the high pressure
coupling of the reel at the use of the burner.
Always unroll the reel hose completely during spraying activities to ensure an
optimal performance!
Disconnect the high pressure coupling: loosen the spray gun coupling from
the reel frame coupling. Couple the high pressure gun to the spray lance before
starting spray activities.
Lock the spray gun coupling again tto the reel frame coupling after use.
20 S U P P O R T A R M
The support arm is mounted at the back, underneath the trailer on the light bar.
Watch out for the crossover point of the support
arm at a filled/unfilled water tank.
Pulling out the support arm can be done by the red handle, the support arm
folds now, set the support arm fixed to the ground by the central bolt (circled in
red on photo 3) and with aid of a wheel bolt/crank. Pull back the red handle and
push the support arm upwards to return to fold.
Attention to compensation of the spring on the axles.
If the supports are lowered completely, they will take the entire weight of the
load and can become damaged. On soft ground, suitable sheet/plate material
has to be laid under the supports.
21 P R E S S U R E R E G U L AT I N G VA LV E
The pressure control valve has a fixed default setting, this is not adjustable.
22 S O F T E N E R P U M P ( O P T I O N AT D E S TA N DA R D V E R S I O N J M B - S )
The trailer is also equipped with a softener pump and softening tank (5 litres),
they are situated on the support plate above the battery. These pump ensures
that the softening product will be pumped to the coil of the burner if the burner
is put into operation (if there's a flame, this means when fuel valve is opened).
This is to prevent scale deposits to the coil of the burner.
See also the manual for operation of the dosage pump!!
• Basic settings softener pump: turn the regulating screw to second position
(2th indication, see mark on the picture left -> 1 liter = 5h 5 mins.) at water
hardness of 20° F when using the DiBO recommended anti scale product
(3.8550.650).
• Softener pump range: 85 ml -> 600 ml/hour.
• Possible options:
DiBO 19
E N
C O M P O N E N T S