Maintenance Table - Stiga HT 500 Li 48 Manuel D'utilisation

• failure to become familiar with the
documentation accompanying the machine;
• carelessness;
• incorrect or forbidden use or assembly;
• use of non-genuine spare parts;
• use of attachments not supplied or
not approved by the manufacturer.
The warranty does not cover:

13. MAINTENANCE TABLE

Intervention
MACHINE
Check all fasteners
Safety checks/check controls
Check the battery charge status
Recharge the battery
Cleaning the machine and the motor
Cleaning and lubrication of the cutting means
Checking for any damage to the machine. If
necessary, contact the authorised service centre.
Checking the cutting means
Sharpening the cutting means
Replacing the cutting-means
* Refer to the battery/battery charger manual.
** The operation must be carried out by your Dealer or an Authorised Service Centre
14. TROUBLESHOOTING
PROBLEM
1. When the safety button
is pressed, the green
light does not come on
2. When the safety button
is pressed, the green
light does not come
on, the LED indicator
(Fig. 3.F) blinks
3. The motor shuts
down whilst working
4. The motor stops
during work and
the LED indicator
(Fig. 3.E) blinks
PROBABLE CAUSE
Battery is not inserted or
is inserted incorrectly
Low battery
Battery is not inserted correctly
Low battery
• normal wear and tear of consumables such
as wheels, blades, safety bolts and wires;
• normal wear and tear.
The purchaser is protected by his or her own
national legislation. The purchaser's rights under
the national laws or his or her own country are
not in any way restricted by this warranty.
Frequency
Before each use
Before each use
Before each use
After each use
After each use
After each use
After each use
After each use
-
-
Make sure that the battery is
inserted well (par. 7.2.3)
Check the battery status and
recharge if necessary (par. 7.2.2)
Make sure that the battery is
inserted well (par. 7.2.3)
Check the battery status and
recharge if necessary. (par. 7.2.2)
EN - 12
Notes
par. 7.5
par. 6.2
*
par. 7.2.2
*
par. 7.3
par. 7.4
-
par. 8.1.1
par. 8.1.2
**
par. 8.1.3
**
SOLUTION