Maintenance Table; Troubleshooting - Stiga HT 500 Li 48 Traduction De La Notice Originale

14. MAINTENANCE TABLE

Intervention
MACHINE
Check all fasteners
Safety checks/check controls
Check the battery charge status
Recharge the battery
Cleaning the machine and the engine
Cleaning and lubrication of the cutting means
Checking for any damage to the machine. If
necessary, contact the authorised service centre.
Checking the cutting means
Sharpening the cutting means
Replacing the cutting means
* Refer to the battery/battery charger manual.
** The operation must be carried out by your Dealer or an Authorised Service Centre

15. TROUBLESHOOTING

PROBLEM
1. When the safety button
is pressed, the green
light does not come on
2. When the safety button
is pressed, the green
light does not come
on, the LED indicator
(Fig. 6.F) blinks
3. The motor shuts
down whilst working
4. The motor stops
during work and
the LED indicator
(Fig. 6.E) blinks
5. The cutting means is
stationary when the
blade control lever
and safety switch
are engaged
6. The cutting means
overheats whilst working
PROBABLE CAUSE
Battery is not inserted or
is inserted incorrectly
Low battery
Battery is not inserted correctly
Low battery
Hedge trimmer is damaged.
Insufficient blade lubrication
Frequency
Before each use
Before each use
Before each use
After each use
After each use
After each use
After each use
After each use
-
-
Make sure that the battery is
inserted correctly (para. 8.2.3)
Check the battery status and recharge
if necessary (para. 8.2.2)
Make sure that the battery is
inserted correctly (para. 8.2.3)
Check the battery status and recharge
if necessary. (para. 8.2.2)
Do not use the hedge trimmer. Immediately
turn off the machine
Contact an Authorised Service Centre.
Turn off the machine, wait until the cutting
means is stationary, remove the battery
and lubricate the blades (para. 8.4)
EN - 13
Notes
para. 8.5
par. 7.2
*
para. 8.2.2
*
par. 8.3
para. 8.4
-
para. 9.1.1
para. 9.1.2
**
para. 9.1.3
**
SOLUTION
remove the battery and