Twin Needle Sewing - Alfa 4900 Manuel D'instructions

q w
26
z
c
x
v
b
n
e
q
w
e
r
t
130

Twin needle sewing

Machine settings
q Pattern:
26 (example)
w Presser foot:
Satin stitch foot F
e Thread tension: AUTO
NOTES:
* When you sew patterns with the twin needle, press the
twin needle button and test the stitches first before you
begin to sew.
* Use the zigzag foot A or satin stitch foot F for twin needle
sewing.
* Turn off the machine before changing the needle.
* Use #60 or finer threads for twin needle sewing.
Use the additional spool pin and spool stand.
Turn on the power switch and press the twin needle button
. Select a pattern and sew.
* The stitch width is limited to 3 mm or less.
q Spool
w Additional spool pin
e Felt
r Spool stand
t Hole for additional spool pin
Threading the machine for twin needle sewing
Place two spools of thread on the spool stand.
Draw both threads from the spools and thread them
through the points from z to n.
Make sure that the two strands of thread do not get
tangled.
Slip one of the threads in the needle bar thread guide on
the left, and the other on the right.
Thread the needles from the front to back with your hand.
NOTES:
Threading from z to v is the same as for a single needle.
The automatic needle threader cannot be used for the twin
needle.
NOTE:
If you select a pattern not suitable for twin needle sewing,
the LCD screen will show a warning message.