Storch PowerCoat FF Mode D'emploi page 137

3. When you are flushing the spray gun, always remove
and clean the suction hose and the screen with water (or
a compatible solvent) and a brush. Then refit the suction
hose.
4. If you have not used an insert, clean the container and
fill it with water or a compatible solvent.
8. Release the trigger lock; turn the nozzle to cleaning
position and actuate the spray gun for 5 seconds to bleed
the spray gun.
5. Refit the material container and shake the spray gun to
clean all its inside areas.
6. Release the trigger lock and actuate the spray gun for
approximately 15 seconds. Lock the trigger lock.
7. Dispose of the contaminated liquid and fill with a suita-
ble flushing liquid.
137 Original instruction