Rohm DURO-M Traduction Du Manuel D'utilisation Original page 91

Turning the wrench, insert new jaws into the respective guide one after the
other:
1. Turn the wrench clockwise until the spiral ring grips the clamping jaws.
Ø Here, observe the order 1-2-3 or 1-2-3-4 or 1-2-3-4-5-6. (Labelling
of jaws and guides: jaw 1 in guide 1, jaw 2 in guide 2, jaw 3 in guide
3, jaw 4 in guide 4, etc.).
Ø Make sure that the jaws do not fall out during insertion. Hold the
jaws until the spiral ring engages.
2. Visually check the centring of the jaws
Ø Use the concentric contour of the for visual control.
3. Turn the wrench anticlockwise to reopen the .
4. Remove wrench.
ü The jaws are replaced.
B1385260 DURO-M
Operation of the lathe chuck | 6
EN
91 / 280