Transport; Personal Protective Equipment And Personnel Qualification - Rohm DURO-M Traduction Du Manuel D'utilisation Original

4 | Transport

4 Transport
4.1

Personal Protective Equipment and Personnel Qualification

When working on and with the Lathe chuck DURO-M, personal protective
equipment must be worn. The owner is responsible for providing personal
protective equipment.
▪ Personal protective equipment must be in perfect condition when carry-
ing out work. Defective safety equipment is to be replaced immediately.
▪ Observe information on personal protective equipment posted in the
working area.
▪ During rotational operation of the Lathe chuck DURO-M, no protective
gloves are to be worn! Hand protection is only to be worn during trans-
port, assembly and maintenance and as long as the Lathe chuck
DURO-M is at a standstill.
Wear protective gloves
Wear safety goggles
Wear ear protection
Wear safety shoes
Wear protective clothing
Work on and with the Lathe chuck may only be carried out by qualified op-
erating and specialist personnel (see Qualification of Operating and Special-
ist Personnel).
78 / 280
Crushing injuries in the event of unsecured transport of the
Lathe chuck.
Falling of the Lathe chuck.
Ø Use suitable hoisting gear and slings.
Ø Wear personal protective equipment.
Ø Do not remain under suspended loads.
WARNING
B1385260 DURO-M