Bernina bernette 10 Mode D'emploi page 36

10 12 15
502020.75.24_021V4D0101_1010_IM_bernette 10 12 15_EN_DE_NL_FR
EN Inserting the needle
Attention:
Turn power switch to "O" before inserting or
removing the needle.
Change the needle regularly, especially
if it is showing signs of wear and causing
problems.
Insert the needle as illustrated:
A. Loosen the needle clamp screw and
tighten again after inserting the new
needle. (1)
B. The flat side of the shaft should be
towards the back.
C/D.Insert the needle as far up as it will go.
Needles must be in perfect condition. (2)
Problems can occur with:
A. Bent needles
B. Blunt needles
C. Damaged points