Table des Matières
Publicité
10
12
15
502020.75.24_021V4D0101_1010_IM_bernette 10 12 15_EN_DE_NL_FR
EN
Inserting bobbin
When inserting or removing the bobbin,
the needle must be fully raised.
- Open the hinged cover (1).
- Remove the bobbin case by pulling its
latch towards you and pulling it out from
the hook.
- Hold the bobbin case with one hand. Insert
the bobbin so that the thread runs in a
clockwise direction (arrow) (2).
- Pull the thread through the slit and under
the finger spring (3).
- Hold the bobbin case by the hinged latch
(4).
- Insert it into the hook (5). Make sure the
bobbin case finger fits into the notch (6) at
the top of the race.
Attention:
Turn power switch to off ("O") before
inserting or removing the bobbin.
Publicité
Table des Matières
