Troubleshooting; Troubleshooting Chainsaw Or Battery - Stihl MSA 160 T Notice D'emploi

English

18 Troubleshooting

18.1 Troubleshooting Chainsaw or Battery

Condition LEDs on Battery
Saw does not start 1 LED flashes
when switched on. green
1 LED glows red. Battery too hot or too cold. ► Engage the chain brake and remove the battery.
3 LEDs flash red. Malfunction in saw.
3 LEDs glow red
4 LEDs flash red. There is a malfunction in
Saw cuts out during 3 LEDs glow red
operation
62
Cause
Battery has low charge.
Chainsaw is too hot.
the battery.
No electrical contact
between the chainsaw and
battery.
Saw or battery damp
Chainsaw is too hot.
Remedy
► Recharge the battery fully as described in the
instruction manual for the STIHL AL 101, 300, 500
chargers.
► Allow battery to cool down / warm up.
► Engage the chain brake and remove the battery.
► Clean contacts in battery compartment.
► Fit the battery.
► Disengage the chain brake.
► Switch on the saw.
► If 3 LEDs continue to flash red: Do not use your
chainsaw and contact your STIHL servicing dealer
for assistance.
► Engage the chain brake and remove the battery.
► Allow chainsaw to cool down
► Engage the chain brake, remove and refit the
battery.
► Disengage the chain brake.
► Switch on the saw.
► If 4 LEDs continue to flash red: Do not use the
battery and contact your STIHL dealer for
assistance.
► Engage the chain brake, remove and refit the
battery.
► Allow saw or battery to dry
► Remove the battery.
► Allow chainsaw to cool down
18 Troubleshooting
0458-706-9921-A