Stihl MSA 160 T Notice D'emploi page 53

6 Assembling the Saw
1
► Unscrew the nut (2).
► Remove the chain sprocket cover (1).
► Turn the tensioning screw (3) counterclockwise until the
tensioner slide (4) butts against the left end of the
housing.
0458-706-9921-A
2
3
4
► Fit the chain in the bar groove so that the arrows on the tie
straps on the top of the bar point in the direction of
rotation.
5
8
6
7
► Fit the guide bar and chain on the saw and check the
following points:
– Chain drive links are seated in teeth of chain sprocket
(5).
– Head of screw (6) locates in slot in guide bar (8).
– Peg of tensioner slide (4) engages hole (7) in guide bar
(8).
The guide bar (8) may be either way round. The logo on the
guide bar (8) may also be upside down.
► Disengage the chain brake.
► Turn the tensioning screw (3) clockwise until the chain fits
snugly against the bar. Make sure the drive link tangs
engage the bar groove.
The guide bar (8) and chain are seated against the saw.
English
3
51