How To Delete The User Pin Policy - iStorage DatAshur PRO2 Manuel D'utilisation

Note: When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

9. How to delete the User PIN Policy

To delete the User PIN Policy, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode (solid
BLUE LED) proceed with the following steps.
1. In Admin mode, press and hold down both
KEY ( ) + 7 buttons
2. Enter 070 and press SHIFT (
Note: When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
#12
is in Admin Mode, the
2
will exit Admin mode automatically - the solid
2
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
) button once
is in Admin Mode, the
2
will exit Admin mode automatically - the solid
2
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
BLUE LED will remain on and solid for 30 seconds only, during which
Solid BLUE
BLUE
Blinking
solid GREEN
indicating the User PIN Policy has been successfully
deleted
BLUE LED will remain on and solid for 30 seconds only, during which
www.istorage-uk.com
BLUE LED switches to a solid
) button for a second - the solid
LED will change to blinking
LEDs
GREEN and BLUE LEDs will change to a
LED and finally to a solid
BLUE LED switches to a solid
) button for a second - the solid
BLUE
2
GREEN and
BLUE LED
BLUE
2