Publicité
place the piece on the conveyor. The DRS will assign the bin, and the
piece will travel to an awaiting iBOT (skip to step 4).
b. The operator can simply drop the piece on the conveyor and let the
MLOCR and DRS software determine the recipient and the bin
assignment. This method can only be used on machines that have the
image capture/MLOCR option installed.
c. An installed auto-feeder can automatically feed stacks of mail onto the
conveyor.
2. Pieces that entered the system without being identified by the operator will
have their picture taken by the camera.
3. The image of the piece captured in step 2 is analyzed by the MLOCR
software, which reports the characters it found to the DRS software. If the
MLOCR and DRS cannot determine a match, the image is sent to an
available Keying Station for operator identification.
4. The conveyor carries the piece to the awaiting iBOT.
5. The next step depends on whether or not the DRS has assigned a bin for
the piece on the iBOT:
34
Figure 21: Keying Station Software
Mail Matrix Operator Manual
OPEX Corporation
Publicité
Chapitres
