Publicité
Optional verifier
A barcode verifier scanner is available as an option. The verifier scanner is
mounted to a bracket on the main charging rail. It is used to confirm that a label
was successfully applied to the mail piece.
Printer-labeler workflow
The workflow of the printer-labeler and general order of operation is described
below:
1. Mail piece moves past the imager and onto the iBOT and the host begins
OCR/DRS bin assignment process.
2. While the DRS bin assignment is in process, the iBOT moves up to the mail
piece detect position, where the iBOT conveyor moves the mail piece
forward to the sensor panel. This causes piece to overhang the iBOT by
approximately ½ inch.
3. When the mail piece reaches the panel, its lower right corner must be
detected by the mail piece sensor. If the sensor does not detect the piece,
no labeling will occur and the iBOT will move the piece to the reject bin.
4. When both the DRS bin assignment and piece detection are confirmed, the
printer begins printing a label for the mail piece.
5. The iBOT moves up toward the label application point.
6. The label is loaded onto the applicator pad.
7. The labeler arm extends.
104
Figure 86: Barcode verifier scanner
Mail Matrix Operator Manual
OPEX Corporation
Publicité
Chapitres
