Publicité
sticking out of the printer. Remove the label gently, and then click the Start
button to continue the job.
7.
Label applied but did not stick to piece:
label on to a piece, but the label did not stick to the piece. Check the labeler
pad and its surrounding areas for the unapplied label, and remove it. Click
the Start button to continue the job.
8.
Labeler pad did not get label from printer:
expected the printer to print out a label, but the labeler was unable to detect
any labels coming out of the printer. Check the labeler pad and its
surrounding areas for an unapplied label, and remove it if found. The
picture below shows a label that the printer printed, but was missed by the
labeler pad. The long arrow indicates the labeler pad, and the short arrow
164
Figure 140: Unexpected label
Mail Matrix Operator Manual
OPEX Corporation
The labeler attempted to apply a
This indicates that the labeler
Publicité
Chapitres
