Publicité
The next step in running your job is to select the options you want to use for the
run. The Run screen's System Modes tab establish how you plan to run the
job.
1. Select the desired Auto Feeder mode, if you have an auto feeder installed:
- Select AUTO to have the feeder send pieces onto the conveyor automat-
ically.
- Select OFF to turn the auto feeder off and drop pieces manually.
Note: The Feeder can be restarted through the Host by toggling the
and OFF buttons.
AUTO
2. Select a Keying mode. The keying mode establishes whether or not the
operator will key in the recipients or if the installed image capture/MLOCR
system will determine the recipient. The options available depend on
whether or not you have the image capture/MLOCR option installed and
whether or not you chose to use the auto feeder in step 1. Select:
- No Keyer if you have image capture/MLOCR installed and do not wish
to have an operator identify recipients.
- From Paper to key in the recipients at the operator station before
dropping the piece.
- From Image to identify recipients based on the image provided by the
installed camera setup.
3. Turn the OCR Assist ON or OFF. This activates the MLOCR function for
analyzing the piece for the recipient information. OCR Assist must be
turned ON if the Keying Mode is set to No Keyer.
Figure 33: System Modes
Mail Matrix Operator Manual
OPEX Corporation
55
Publicité
Chapitres
