Publicité
Labeler Response Missing
Description
This jam occurs if the labeler is not communicating properly with
the Real-Time Controller.
Resolution
Press the Start button and resume the job. If this problem
persists please call OPEX service.
Labeler Skew Sensor Blocked
Description
This jam occurs when the labeler skew sensor is blocked.
Resolution
Locate the skew sensor using the photos and descriptions
below. Check for any obstruction in the path of the sensor or for any
disconnected wiring. If an obstruction is found, remove the obstruction and
then press the Start button to resume the job. If the problem persists or wiring
issues are found, please call OPEX service.
The skew sensor is mounted on a metal plate below the labeling pad, in the
loading column. It actually consists of two parts – the bottom part is located on
the inside of the plate (loading column side), and the top part is outside the
plate (labeler side).
The arrow in this photo shows the bottom part of the skew sensor, with no
obstructions.
166
Figure 142: Skew sensor
Mail Matrix Operator Manual
OPEX Corporation
Publicité
Chapitres
