Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Electric pallet truck EGU PS 15
English
3.4
Handling
3.4.1 Before taking into operation check:
Perfect function of the operating elements
Function of the brakes, parking- and operating brake!
Make a brake test!
Acid level and charging state of the battery
State of the travelling rollers, firm seat of the wheel screws and roller axles
Function of the safety button
Check the function of warning horn
Load chains for adjustment, chain tension, wear and lubrication.
3.4.2 Driving and Braking
Plug the safety key into the key-operated switch and turn to the right until it stops. The electric pallet
truck is ready for travelling and the operating elements of the lifting hydraulic may be actuated.
Bring the tie bar into driving range
Control the driving direction and speed with the rotary finger lever (
Due to safety reasons, changing of the driving direction should only be effected from a standstill after
having fully braked.
Touching the safety button on the tie bar head automatically leads to a switching to counter drive (driv-
ing direction "V"), thus providing additional protection for the operating person.
In no case may the safety button be used for shunting of the electric pallet truck.
The operating brake is to be actuated according to the respective situation. Long delay or even jerky
braking causes danger of accidents.
Suddenly letting of the tie bar leads to full braking (mechanical parking brake) and should be avoided.
Actuating the parking brake (upper and lower tie bar position,) automatically switches off the driving cur-
rent.
When leaving the pallet truck, take out the safety key. Bring the tie bar into upper braking position.
Completely lower the fork.
In case of danger - pump- or driving motor cannot be switches off - pull out the battery plug. Thus, an
emergency stop of all electrically effected movements is achieved.
In current-free state, the parking brake is closed. Lowering of the fork is still possible.
3.5
Loading
Make sure the load does not exceed
the carrying capacity of the pallet
truck.
Slowly drive to the stacking area. Level
forks to equal height with the pallet and
move into the pallet until the back of
the fork touches the load (pallet).
Bring the tie bar into upper braking po-
sition and slightly lift the load. Slowly
start to drive and lower the load.
The load must be distributed as
evenly as possible on both fork legs
and fork over the entire length.
It is strictly forbidden to carry loose
stacked goods.
technische Änderungen vorbehalten
design changes under reserve
F 08.01.161
yes
changements techniques sous réserve
no
21
Publicité
Table des Matières
