Control Panel - MarelliMotori D-Vo Light Manuel D'utilisation

Tools
Set language
Set password
Help
Check for updates
About
AboutQt

7.3.2. Control panel

This area contains items used to activate, deactivate and control the functions/states listed below.
9638571A0_C
It allows to change the D-Vo Dashboard language
It allows to set a password protecting access to D-Vo Dashboard
It checks for any D-Vo Dashboard updates
Information about the serial number and the hardware, software and firmware versions
Information on the D-Vo Dashboard application
Connection state LED
•
Red: D-Vo not connected (OFFLINE state).
•
Green: D-Vo connected (ONLINE state).
CONNECT / DISCONNECT
Clicking this button starts communication between the PC and D-Vo (OFFLINE →
ONLINE).
Once connection is established, D-Vo Dashboard directly loads into the interface all
the parameters of the connected D-Vo.
Clicking the button again cuts off the communication (ONLINE → OFFLINE).
RAISE
It increases the setpoint of the active operating mode.
If you hold the cursor pressed on the button, the setpoint of the controlled quantity in
the active operating mode increases linearly according to the traverse rate defined in
the Setpoint page, until the button is released.
A quick click, or a click lasting less than 400ms shall have no effect on the setpoint.
The RAISE virtual button operates in parallel with the RAISE physical contact with the
following OR logic:
Physical contact
RAISE
Open
Open
Closed
Closed
LOWER
It decreases the setpoint of the active operating mode.
If you hold the cursor pressed on the button, the setpoint of the controlled quantity in
the active operating mode decreases linearly according to the traverse rate defined in
the Setpoint page, until the button is released.
A quick click, or a click lasting less than 400ms shall have no effect on the setpoint.
The LOWER virtual button operates in parallel with the LOWER physical contact with
the following OR logic:
2
Virtual button
RAISE
Released
Pressed
Released
Pressed
D-Vo Light – Marelli Motori
Command
to D-Vo
No action
It increases the setpoint
It increases the setpoint
It increases the setpoint
EN 40