Changing The Door Opening Direction; Flush-Fitting; Commissioning - Eurocave Wine Bar 2.0 Mode D'emploi

Changing the door opening direction

To change the direction in which the door opens, please follow the
instructions in the diagram below:
Installing the
appliance in a
corner
Please observe the following
installation instructions:
Flush-fitting one single
Wine Bar 2.0
40 mm
100 mm
170 mm
200 mm
30 mm
100 mm
10 mm

6 - COMMISSIONING

1. Use
Wine Bar 2.0 is designed to bring non-sparkling wines (white, rosé or red) to the correct serving temperature and
protect them from oxidation once opened.
The appliance must never be used for sparkling wines (Champagne etc.)
Wine Bar 2.0 is designed to store:
2 bottles of red or white/rosé wine or 1 bottle of red wine + 1 bottle of white/rosé wine or 1 single bottle, whether
these bottles are open (vacuum sealing) or closed (bringing wine to the correct serving temperature).
With Wine Bar 2.0, your open bottles of wine retain all of their flavours, for up to 10 days.
30 mm mini
The key to an optimal wine drinking experience
1) Serving wine at the correct temperature:
In order to fully develop all of their flavours, wines must be
brought to the correct serving temperature. A wine kept at a
temperature which is too high will seem too alcoholic. On the
-GB8-
3
2.5
2
2.5
1
Flush-fitting 2 Wine Bar 2.0
appliances side by side
Leave 10 mm free around the product
and 40 mm at the back.
Opposite the ventilation inlets, located
on either side of the Wine Bar, two holes
(100x200mm) are required to ensure
removal of air and allow the product to
operate correctly.
10 mm
40 mm
100 mm
170 mm
200 mm
30 mm
10 mm
100 mm
10 mm
100 mm mini
4
5
6
2.5
10 mm
10 mm
contrary, a temperature which is too low will dull the flavours
and prevent them from fully expressing themselves. The correct
serving temperature for white/rosé wines is 8°C - 10°C / 46 °F -
50°F. That of red wines is 16°C - 18°C / 60°F-64°F.
Wine Bar 2.0 respects your wine, which is why it brings it to the
correct serving temperature gradually.
30 mm

Flush-fitting

100 mm
10 mm
The Wine Bar 2.0 can be flush-fitted.
Observe the following instructions:
30 mm mini
Installing the side by side
kit
Instructions to observe if installing one
or more Wine Bar 2.0 appliances side by
side: Maintain a distance of 30 cm between
the two power supplies or any other heat
source
2
2.5
1
Installation kit supplied with the product:
plate, 2.5 Allen key; 4 screws.
10 mm
100 mm mini
>30cm